Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 277)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-29
d. Input the register number.
Note:
See item 8.1.4 “Symbol Definition” for inputtable symbols.
5. Input by parameters
a. Input a parameter. Parameters are either in decimal (integer, 32-bit integer, real
number) or hexadecimal (integer, 32-bit integer) form. Set the input mode to
Operand input.
b. Select the command. The cursor appears at the parameter input position.
c. Input the parameter.
Supplement:
Parameter input format
The formats during parameter input are displayed in the following chart.
Input Value
Screen
Display
Input
Example
Description
Decimals
Integer 00100 100 Uses ‘0’~’9’. Input ‘-’ to the head of the load amount.
32-bit Integers 0000010000 10000L Uses ‘0’~’9’. Input ‘L’ to the end of the value. Input ‘-’ to the
head of the load amount . 32-bit integers are automatic if ‘L’ is
not input when “Input value > 32767” or “Input value <-
32768”.
Real Numbers 100.1E 100.1E Uses ‘0’~’9’. Input ‘E’ to the end of the value. Input ‘-’ to the
head of the load amount . Real numbers are automatic if ‘.’ is
included in the input value, even if ‘E’ is input.
Hex
Integers H32FF H32FF Input ‘H’ to the head of the value. Uses ‘0’~’9’ and ‘A’~’F’.
32-bit Integers H000032FF H32FFL Input ‘H’ to the head of the value. Uses ‘0’~’9’ and ‘A’~’F’.
Input ‘L’ to the end of the value. 32-bit integers are automatic
even if ‘L’ is not input if the input value is 4 places or higher.
1 0000
SYM1