Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 297)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-49
i. Input the coil command.
Note:
Setting of branch points, join points, and join connections can be done either when the
cursor is on the time limit setting value or on the calculation register.
6. Serial Connection
If no join points or join connections are designated, the next contact is connected in
series, and the cursor moves to the right of the current command position. Serial con-
nections are operated regardless of whether a branch is made within them, and there is
no limit to the number of contacts. If the number of serial connections exceeds one, as
shown in the following figure, the column position of the next command input is
changed and displayed.
0B00001
1 0000
IB00000
0B00000
1 0003
005.00
IB000001
1 0005
MW00010
T
IB000002
1 0000
IB00000
1 0003
IB00001 IB00002 IB00003 IB00004
IB00004 0B00000
Back to Back
Back to Back continues