Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 207)

MotionSuite™ Series Machine Controller Software Manual Chapter 7: System Data Definition
7-34
12. Start-up Memory Status
This displays the memory status upon start-up in the on-line mode.
13. Calendar (Date/Time)
This shows the calendar values of the PLC internal clock. Calendar values can
be changed in the on-line mode. Calendar values cannot be displayed in the off-
line mode.
14. CPU Multi-System Operation Mode
Sets the operation mode in the CPU multi-system.
Harmony Stop : Stopping of one CPU in conjunction with the stopping of
another CPU
Stand Alone : No effect from the stopping of a given CPU
Set “Harmony Stop” in the MotionSuite™ series machine controller.
15 Sync Scan
This sets the synchronous scanning of the CPU multi-system.
H/L : Synchronizes both high-speed scan and low-speed scan
H only : Synchronizes high-speed scan only
L only : Synchronizes low-speed scan only
No sync : Both CPUs operate asynchronously
Set H only in the MotionSuite™ series machine controller.
7.4.3 Setting of Common Memory Assignment Data
This item deals with the setting and deletion of common memory assignment data.
Setting of Common Memory Assignment Data
In multi-CPU configuration, it is possible to input/output M register data between var-
ious CPUs at a designated scan. In the Common Memory Assignment tab, use the M
register as the global memory, and set whether to input/output a given range at a given
scan. The following screen is displayed by opening the System Configuration window
and clicking the Common Memory Assignment tab.