Yaskawa MotionSuite Series Machine Controller Software Manual User Manual
Page 363
MotionSuite™ Series Machine Controller Software Manual
Chapter 9: Motion Programming
9-11
Last
This function jumps the cursor to, and displays the final line of, the program. Select Edit
(E) and Last (E).
Semicolon
Enable/Disable functions by selecting Edit (E) and then Semicolon (I). Add a semicolon
(;) to the final column of a program line by pressing the enter key during column input. A
semicolon is necessary in the final column of a program line due to constraints arising
from the motion language specifications. This function is meant to reduce the program-
ming input load. As shown in the figure below, a check mark before Semicolon indicates
that the function is enabled. If disabled, select Edit (E) and then Semicolon (I) again.
Cursor
When enabled,
this button is
depressed.