Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 214)

MotionSuite™ Series Machine Controller Software Manual Chapter 7: System Data Definition
7-41
4. Number of Steps
The total number of drawing/function program steps for each PLC is displayed.
Start-up Drawings:
The total number of start-up drawing steps is displayed for each PLC.
Interrupt Drawings:
The total number of interrupt drawing steps is displayed for each PLC.
User Functions:
The total number of user function steps is displayed for each PLC.
5. Total Number of Steps
The total number of steps for all drawings in each PLC is displayed.
6. Program Memory
The amount of program memory used in each PLC is displayed.
Total: The total amount of program memory is displayed here. 0 is dis-
played in the off-line mode.
Available: The amount of program memory available is displayed. 0 is dis-
played in the off-line mode.
Supplement
In the on-line mode, the maximum value can be cleared to 0 by inputting 0 in the “Maxi-
mum Value” box for scan time, and executing the save operation. Adoption of a new max-
imum value begins after clearing.
7.5.3 Saving Scan Time Settings
This function saves scan time setting data. The data is saved to both the PLC and hard
drive in the on-line mode, and to the hard drive only in the off-line mode. Save scan
time setting data by the following procedure:
a. Select Save (S) from File (F) in the scan time menu.
b. Select the Yes (Y) button from the scan time message box.
7.5.4 Closing Scan Time Settings
Close scan time setting by closing the scan time window. To close the window, select
Close (C) from File (F) in the scan time menu.