Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 254)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-6
gram so as not to exceed the regions set into the program. An Operation Error
results if an area is exceeded and a D register or # register is read or written.
8.1.3 I/O Definition
When the I/O Definition tab is clicked in the Property window, the following screen is
displayed. Define function program I/O in this screen.
1. Number of Function Inputs
Input the number of function inputs from 1~16.
2. Number of Function Outputs
Input the number of function outputs from 1~16.
3. Number of Address Inputs
1 if addresses are to be input, 0 if not.
1
2
3
4
5
6
7
8