Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 155)

MotionSuite™ Series Machine Controller Software Manual Chapter 6: Module Configuration
6-11
Each setting value is previously determined by the system. Therefore, it is not neces-
sary to set them up again, unless there is an exception.
1. Tab Name
Select the tab to be set up.
2. Transmission Protocol
Select the transmission protocol.
3. Master/Slave
Select the PLC for master or slave.
4. Device Address
Select the device address. Set up “0” when the master is selected, select a device
address between 1 ~ 247 when the slave is selected.
5. Serial I/F
Select the RS-232C.
Memobus Yaskawa Standard Memobus Process
No process
According to the user application program,
transfer any data in any timing
1
2
3
4
5
6
7
8
9
10