Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 349)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-101
e. Go To
This function moves the cursor to a desired row.
e.1 Select Go To (T) from View (V) in the Column Attribute menu.
e.2 In the dialogue box, input the row number to be jumped to, and select the
OK button.
e.3 The cursor moves to the row input in (e.2).
f. Changing Table Definitions
This function changes the table data table type.
f.1
Select Change (H) from File (F) in the Column Attribute menu.
f.2 In the Table Definition Setting dialogue box, input the change content, and
select the OK button.
Note:
Table definitions cannot be changed when the table data window is open. Moreover,
table names cannot be changed. It is not possible to change data other than table com-
ments in the on-line mode. See Item 8.6.3 “Table Operation in the List Window: New
Table Data Creation.”
8.6.7 Saving Row Attributes
This function saves row attribute data. The data is saved to both the PLC and hard
drive in the on-line mode, and into the hard drive in the off-line mode.
a. Select Save (S) from File (F) in the Column Attribute menu.
b. Select the Yes (Y) button in the message box.
c. Select the OK button in the message box.
Note:
When a save fails, an error detection message box is displayed.