Yaskawa MotionSuite Series Machine Controller Software Manual User Manual
Page 153
Advertising
MotionSuite™ Series Machine Controller Software Manual
Chapter 6: Module Configuration
6-9
6.3 Opening the Definition Window of the Module in the Slot
This section describes how to open the Definition window of each module installed in
the slot. There are two (2) ways, shown as follows:
a. Opening from the File (F) Menu
Open the Module Definition window of the selected slot number.
In this case, the General Serial Definition window is opened, because the
RS-232C is selected.
b. Opening by the Slot Number
Double-click the number of the slot in which the module is installed.
In this case, the General Serial Definition window is opened, because the
RS-232C is selected.
Advertising