Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 447)

MotionSuite™ Series Machine Controller Software Manual Chapter 12: Printing
12-27
4. Cross-reference Data
The cross-reference data written out from the register is printed here.
5. Program
The main program content is printed here.
6. Cross-Reference Data
Cross-reference data is printed for coil commands and storage commands. How-
ever, program titles are printed for SEE commands and FSTART commands. A
“...” printed at the drawing position of the cross-reference data indicates a
metadrawing. Furthermore, types of writing in which $, &, or @ are printed at
the end of the cross-reference data are as follows:
$ : Coil commands (— —) and storage commands ( ⇒).
& : Transmission commands such as MOVW, XCHNG< ROTL, ROTR,
etc.
@ : Pulse, total registers.
7. Creation Date
The data printed in the Draw box is the data in the Creator box in the print win-
dow, and the data printed in the Data box is the data in the Creation Date box.
8. Program Data
The drawing number and program type are printed here.
9. Title
The program title is printed here.
10. Drawing Number
The data in the Drawing Number box in the print window is printed here.
11. Page Numbers
The page numbers are printed here. The initial value is the data in the Page
Number box of each of the tabs in the print window.