Yaskawa MotionSuite Series Machine Controller Software Manual User Manual
Page 296
Advertising
MotionSuite™ Series Machine Controller Software Manual
Chapter 8: Ladder Programming
8-48
c. Input the time limit setting values (parameters or register numbers) which are
ON delay command operands.
d. Input calculation register numbers which are ON delay command operands.
e. After selecting the normally open (NO) contact command, set the branch and
join points.
f. Input the register numbers which are operands of the normally open (NO) con-
tact command.
g. Input the coil command.
h. Input the normally open (NO) contact command.
1 0000
IB00000
T
005.00
1 0000
IB00000
005.00
MW00010
T
1 0000
IB00000
1 0003
005.00
MW00010
T
1 0000
IB00000
1 0003
005.00
MW00010
T
0B00000
IB000001
1 0000
IB00000
0B00000
1 0003
005.00
IB000001
1 0005
MW00010
T
IB000002
Advertising