6 reset error, 7 delete logbook, Reset error – Lenze 8400 User Manual
Page 106: Delete logbook, 4device control (dctrl)
4
Device control (DCTRL)
4.1
Device commands (C00002/x)
106
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1.6
Reset error
The
= "1: On / start" device command acknowledges an existing error message if the
error cause has been eliminated and thus the error is no longer pending.
• After the reset (acknowledgement) of the current error, further errors may be pending which
must also be reset.
• The status determining error is displayed in
.
• The current error is displayed in
.
Tip!
An error message can also be acknowledged by activating the Reset error button in the
Diagnostics tab.
Detailed information on error messages can be found in the "
4.1.7
Delete logbook
The
= "1: On / start" device command deletes all logbook entries.
Tip!
To display the logbook in the »Engineer«, click the Logbook button on the Diagnostics tab.
In the Logbook dialog box, it is also possible to delete all logbook entries by clicking the
Delete button.
Detailed information on the logbook can be found in the "