4 touch probe positioning, Touch probe positioning, Touch probe positioning ( 521) – Lenze 8400 User Manual
Page 521: 8basic drive functions (mck)
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
521
8
Basic drive functions (MCK)
8.8
Positioning
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.8.2.4
Touch probe positioning
This function extension is available from version 06.00.00!
In case of a touch probe positioning, first the profile is executed according to the set profile
parameters. If a touch probe is detected during the process, it is automatically changed to the profile
defined in the "TP profile" profile parameter. This profile mode is also defined via the mode selection
like in the following profile start processes.
If no valid TP profile is set, the travel request is aborted ("PosStop").
Preconditions for touch probe positioning
• The mode of the current profile data set contains the setting "to TP".
• For absolute positioning, the home (reference) position must be known.
• In the corresponding profile data set, the following profile parameters must be set in addition:
• TP profile (
)
• TP signal source (
)
• The touch probe interface is configured such that the selected TP signal source is enabled.
• See chapter entitled "
Note!
and select the edge, the digital input used for the connection of the
touch-probe sensor is to respond. In the Lenze setting of
, no touch probe is
detected!