Lenze 8400 - Manual (Page 504)

8 Basic drive functions (MCK)
8.6 Homing
504
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.6.3.1 Homing on the fly
With referencing "on the fly", the home position of a machine can be set during ongoing movement.
Jerking and compensating movements do not occur.
The following illustration shows the relevant interfaces for selecting the home position at the
SB LS_MotionControlKernel and SB LS_MotorInterface :
[8-25] Interface for selecting the home position
In order that position selections can be accepted while homing on the fly, an additional connection
is required in the application level.
• The following illustration shows the required modification using the example of the "table
positioning" technology application.
• For transmitting the home position from the I/O level to the application level, the "free" input
dnFreeIn1_p is used here:
[8-26] Modified interconnection for selecting the home position
 Selection of the home position
 Setting of the home position with bit 9 ("HomeSetPos") = 1
/6B0RWRU,QWHUIDFH
GQ0RWRU5HI2IIVHWBS
" /6B0RWLRQ&RQWURO.HUQHO "
GQ0RWRU5HI2IIVHWBSB
E0RWRU5HI2IIVHW2QB E0RWRU5HI2IIVHW2Q
GQ0RWRU5HI2IIVHWBS
Z0RWLRQ&RQWURO
n
o
 I/O level
 Application level
 Setting of the home position
 Selection of the home position
/6B0RWRU,QWHUIDFH
GQ0RWRU5HI2IIVHWBS
" /6B0RWLRQ&RQWURO.HUQHO "
GQ0RWRU5HI2IIVHWBSB
E0RWRU5HI2IIVHW2QB E0RWRU5HI2IIVHW2Q
GQ0RWRU5HI2IIVHWBS
/$B7DE3RVB,Q " 
GQ)UHH,QBS
/$B7DE3RV "
E+RPH6HW3RVLWLRQ
GQ)UHH,QBS
n
o