Lenze 8400 - Manual (Page 227)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
227
5 Motor control (MCTRL)
5.9 Servo control (SC)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.9.3.1 Parameterising the encoder/feedback system
Required settings:
1. Parameterise the function of the digital inputs 1 and 2 as the encoder input in C00115 .
2. Set the encoder increments in C00420/1 .
3. Select the speed sensor in C00495 .
4. Adapt the filter time of the actual speed filter in C00497 .
5. In the case of encoders with a very low resolution (number of increments < 120 increments):
Change the encoder evaluation procedure in C00496 if necessary.