Lenze 8400 - Manual (Page 507)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
507
8 Basic drive functions (MCK)
8.7 Manual jog
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.7.1.1 Functional settings
In C01230 , various functional settings for manual jogging can be carried out in bit-coded form.
Function Lenze setting
Bit 0 Manual jog with intermediate stop
During manual jog, a stop is automatically made at the breakpoint positions set in
C01234/1...4 .
• The home position must be known for this function.
• Travelling is continued when the pushbutton is "released" and pressed again. This button
has been assigned the ManJogPos and/or ManJogNeg control function.
Off
Bit 1 Time-based start of second speed
In manual jog mode, an automatic changeover to manual speed 2 takes place after a
parameterisable waiting time.
 Time-based start of second speed ( 509)
Off
Bit 2 HW limit switch on
In the "manual jog" operating mode, a travel range monitoring mode via hardware limit
switch is active.
 Limit position monitoring ( 474)
Off
Bit 3 SW limit switch on
In the "manual jog" operating mode, a travel range monitoring mode via parameterised
software limit positions.
 Limit position monitoring ( 474)
Off
Bit 4 Reserved Off
Bit 5 Reserved Off
Bit 6 Reserved Off
Bit 7 Position controller off
In the "manual jog" operating mode, the position controller is deactivated. Thus, the
compensation of the following error is switched off.
Off