Lenze 8400 - Manual (Page 756)

16 Parameter reference
16.2 Parameter list | C00066
756
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00066
C00070
C00071
C00072
Parameter | Name:
C00066 | Thermal motor load (I²xt)
Data type: INTEGER_16
Index: 24509
d
= 5FBD
h
Display of the thermal motor load, sensorlessly determined using a motor model
• If the value displayed here exceeds "100.00 %", the error message "OC6: Thermal motor overload (I2xt)" is output
and the fault response set in C00606 is executed (default setting: "Warning").
 Motor overload monitoring (I2xt)
Display range
(min. value | unit | max. value)
0.00 % 199.99
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00070 | Vp speed controller
Data type: UNSIGNED_16
Index: 24505
d
= 5FB9
h
Amplification factor Vp of the speed controller for different motor control modes
Setting range
(min. value | unit | max. value)
0.00 600.00
Subcodes Lenze setting Info
C00070/1 15.00 SLVC : Vp speed controller
C00070/2 6.00 SC : Vp speed controller
C00070/3 3.00 SLPSM: Vp speed controller
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00071 | Ti speed controller
Data type: UNSIGNED_16
Index: 24504
d
= 5FB8
h
Reset time Ti of the speed controller for different motor control modes
Setting range
(min. value | unit | max. value)
0.0 ms 6000.0
Subcodes Lenze setting Info
C00071/1 100.0 ms SLVC : Ti speed controller
C00071/2 50.0 ms SC : Ti speed controller
C00071/3 100.0 ms SLPSM: Ti speed controller
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10
Parameter | Name:
C00072 | SC: Tdn speed controller
Data type: UNSIGNED_16
Index: 24503
d
= 5FB7
h
Differential time constant Tdn of the speed controller for servo control ( SC )
Setting range (min. value | unit | max. value) Lenze setting
0.00 ms 3.00 0.00 ms
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100