Lenze 8400 - Manual (Page 302)

6 I/O terminals
302
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 I/O terminals
This chapter provides information on the function, possible parameter settings, and technical data
of the input/output terminals of the controller.
In the »Engineer«, the input and output terminals are parameterised on the Terminal assignment
tab. To do this, go to the Control terminals list field and select the terminals that you wish to
parameterise:
You can find further information in the respective subchapter:
 Digital terminals ( 303)
 Analog terminals ( 326)
 Touch probe detection ( 331)

Tip!
How you can alter the preconfigured assignment of the input and output terminals is
described in the chapter entitled " User-defined terminal assignment ". ( 339)

Note!
The input and output terminals of the drive controller have already been functionally
assigned in the default setting ("Lenze setting"). The preconfigured assignment depends
on the technology application selected in C00005 and the control mode selected in
C00007 :
• TA "Actuating drive speed": Terminal assignment of the control modes ( 359)
• TA "Table positioning": Terminal assignment of the control modes ( 389)
• TA "Switch-off positioning": Terminal assignment of the control modes ( 415)

Wiring diagram, assignment and electrical data of the input and output terminals can be
found in the 8400 protec hardware manual in the chapter "Technical data".
• The hardware manual has been stored in electronic form on the data carrier supplied
with the 8400 drive controller.