Lenze 8400 - Manual (Page 1242)

18 Function library
18.1 Function blocks | L_Curve_1
1242
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
18.1.67.1 Function 3: nOut_a = f(table)
If function 3 has been selected in C00960 , the output value is calculated according to a
characteristic.
• The characteristic may comprise up to 32 interpolation points which are defined by parameters.
• If the nIn_a input value is equal to one of the X interpolation points, the corresponding Y
interpolation point will be output to nOut_a.
• If the nIn_a input value lies between two X interpolation points, the nOut_a output value will
be interpolated linearly:
[18-22] Linear interpolation between two interpolation points
C00963/1...32 -32767 32767 X values for characteristic function
• Subcodes 1 ... 32 correspond to
interpolation point values
X1 ... X32.
• ±16384 ≡ ±100 %
• Lenze setting: 0
 Function 3: nOut_a = f(table)
C00964/1...32 -32767 32767 Y values for characteristic function
• Subcodes 1 ... 32 correspond to
interpolation point values
Y1 ... Y32.
• ±16384 ≡ ±100 %
• Lenze setting: 0
 Function 3: nOut_a = f(table)
Parameter Possible settings Info
As per the equation,
output value nOut_a for nIn_a is calculated as follows:
nOut_a
nIn_a X
n
X
n+1
Y
n
Y
n+1
Y
n+1
- Y
n
X
n+1
- X
n
y
x
X
n+1
X
n
–
Y
n+1
Y
n
–
------------------------
nIn_a X
n
–
nOut_a Y
n
–
-------------------------------- =
nOut_a
nIn_a X
n
– ( ) Y
n+1
Y
n
– ( ) ⋅
X
n+1
X
n
–
----------------------------------------------------------------- Y
n
+ =