Lenze 8400 - Manual (Page 92)

3 Commissioning
3.10 PC manual control
92
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.10.4 Manual jog
In the "Manual jog" mode, the drive can be traversed manually in a clockwise or counter-clockwise
direction.
The change to the "Manual jog" mode can be made by selecting the correspondent option on the
Positioning tab:
• The profile parameters saved in the parameter set for the basic "manual control" function are
used:

How to traverse the drive manually in inching mode:
1. If the controller is still inhibited, enable the controller via the Enable controller button.
• Please note that the controller is only enabled if no other sources of a controller inhibit
(e.g. terminal RFR) are active.
If the controller is in the "OperationEnabled" status:
2. Click << Left or Right >> (and keep it pressed) to traverse the drive in the corresponding
direction of rotation.

You can find detailed information on the "Manual jog" mode in the chapter entitled
"Basic drive functions" in the subchapter " Manual jog ". ( 505)
Parameter Lenze setting Info
Value Unit
Speed 1
( C01231/1 )
360.0000 units/s Speed for manual jog
Acceleration
( C01232/1 )
720.0000 units/s 2 For accelerating and decelerating, different values can
be set so that smooth starting and quick stopping of the
drive can be implemented.
Delay
( C01232/2 )
720.0000 units/s 2
S-ramp time
( C01233/1 )
0.000 s In order to reduce jerking, the two ramps can be set in
such a way that they are s-shaped. This is done by
entering a relative S-ramp time.