Lenze 8400 - Manual (Page 99)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
99
4 Device control (DCTRL)
4.1 Device commands (C00002/x)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Short overview of device commands
Device commands described in this chapter:
Device commands described in other chapters:
C00002
Subcode:
Device command Controller
inhibit
required
Status information
1 Load Lenze setting  dynamic
6 Load all parameter sets  dynamic
11 Save all parameter sets dynamic
16 Enable/Inhibit controller static
17 Activate/deactivate quick stop static
19 Reset error static
21 Delete logbook static
27 Device search function
(from version 06.00.00)
static
C00002
Subcode:
Device command Controller
inhibit
required
Status information
23 Motor parameter identification
 Automatic motor data identification
 dynamic
26 CAN reset node
 Reinitialising the CANopen interface
static
28 Check MasterPin
(from version 06.00.00)
 Unlocking the controller with a MasterPin
 static
29 Set binding ID
(from version 06.00.00)
 Device personalisation
static
30 Delete binding ID
(from version 06.00.00)
 Device personalisation
static
31 Set password
(from version 06.00.00)
 Password protection
static
32 Check password
(from version 06.00.00)
 Password protection
static
33 Delete password
(from version 06.00.00)
 Password protection
static