Lenze 8400 - Manual (Page 111)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
111
4 Device control (DCTRL)
4.2 Device state machine and device statuses
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.3 Ident
The controller has been provided with the "Motor parameter identification" function for automatic
identification of the motor parameters. If the motor parameter identification is active, the
controller is in the "Ident" device status.
The "Ident" device status can only be reached from the "
SwitchedOn " device status, i.e. the
controller must be inhibited first so that identification can be started afterwards via the
corresponding device command:
After the motor parameter identification is completed, the status changes back to " SwitchedOn ".
"DRV-RDY" LED "DRV-ERR" LED Display in C00137 Display in status word 1 ( C00150 )
Bit 11 Bit 10 Bit 9 Bit 8
OFF Ident 0 0 1 0
Device command Function Detailed information
C00002/23 Motor parameter identification  Automatic motor parameter identification

Stop!
While the motor parameters are detected,
• the controller does not respond to setpoint changes or control processes (e.g. speed
setpoints, quick stop, torque limitations),
• the application remains active,
• all system interfaces (IO, bus systems, etc.) remain active,
• error monitoring remains active,
• the inverter is controlled independently of the setpoint sources.