Lenze 8400 - Manual (Page 28)

2 Introduction: Parameterising the controller
2.1 Integrated technology applications
28
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.1 Integrated technology applications
The following technology applications integrated in the drive controller 8400 protec HighLine
provide the main signal flow for the implementation of a general or a special drive solution:
Technology application "Actuating drive speed"
This preset technology application serves to solve speed-controlled drive tasks, e.g.
conveyor drives (interconnected), extruders, test benches, vibrators, travelling drives,
presses, machining systems, metering units.
Technology application "Table positioning"
This technology application serves to solve position-controlled drive tasks which are
normally controlled by a higher-level control via a fieldbus, e.g. transport facilities,
rotary tables, storage and retrieval units, feed drives, metering units, hoists.
Note: An external sequence control is required for this TA!
Technology application "Switch-off positioning"
This technology application is used to solve speed-controlled drive tasks which
require a pre-switch off or stopping at certain positions, e.g. roller conveyors and
conveying belts. The pre-switch off is implemented by connecting switch-off sensors.

Note!
Please note that the "StateLine" and "HighLine" device types differ with regard to the
number, functional range, and flexibility of the technology applications offered.

Detailed information on each technology application can be found in the main chapter
" Technology applications ". ( 346)