Lenze 8400 - Manual (Page 636)

11 CANopen option
11.4 Going online via the system bus
636
Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11.4 Going online via the system bus
The system bus (CANopen) can also be used for the communication between the »Engineer« and
the controller, alternatively to the USB diagnostic adapter.
• Lenze offers the following communication accessories for connection to the PC:
11.5 Reinitialising the CANopen interface
The C00002/26 = "1: On / start" device command reinitialises the CANopen interface of the
controller ("Reset node"), which is required after e.g. changing the data transfer rate, the node
address or the identifiers, respectively.
Communication accessories PC interface
PC system bus adapter 2173
incl. connection cable and voltage supply adapter
• for DIN keyboard connection (EMF2173IB)
• for PS/2 keyboard connection (EMF2173IBV002)
• for PS/2 keyboard connection with electrical isolation (EMF2173IBV003)
Parallel interface
(LPT port)
PC system bus adapter 2177
incl. connection cable (EMF2177IB)
USB
(Universal Serial Bus)

Note!
• For detailed information about the PC system bus adapter, please see the "CAN
Communication Manual".
• Please observe the documentation for the PC system bus adapter!
• In the »Engineer«, go to the Device assignment offline devices dialog box and select the
"System bus CAN" entry from the Bus connection list field to establish an online
connection.