2 changing the terminal assignment with the keypad, Changing the terminal assignment with the keypad, 6i/o terminals – Lenze 8400 User Manual

Page 341

Advertising

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05

341

I/O terminals

6.5

User-defined terminal assignment

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

6.5.2

Changing the terminal assignment with the keypad

You can reconfigure the preconfigured terminal assignment with the keypad (and with the

»Engineer«) by means of so-called configuration parameters.

• Each configuration parameter represents a signal input of a system block or application block.
• Each configuration parameter contains a selection list with output signals of the same type of

data.

• Logical linking is thus carried out by selecting the output signal for the corresponding signal

input.

In the following example, digital output 1 (LS_DigitalOutput.bOut1 input) is logically linked to the

status signal "Drive ready" (LA_nCtrl_bDriveReady output signal):

Configuration parameters for the digital output terminals
The subcodes of

C00621

serve to change the preconfigured terminal assignment of the digital

output terminals:

Other subcodes (not shown here) allow the configuration of input signals of different system blocks

and port blocks.

Configuration parameters for the inputs of the technology application
The following parameters can be used to change the preconfigured assignment of the application

inputs:

Parameter

Info

Lenze setting

Value Unit

Digital outputs - terminal assignment

C00621/2

LS_DigitalOutput:bOut1

1000: LA_nCtrl_bDriveReady

C00621/99

LS_DigitalOutput: bOut2

0: Not connected