Dell Emulex Family of Adapters - Manual (Page 1086)

Emulex Drivers Version 10.2 for VMware ESXi User Manual P010087-01A Rev. A
4. Troubleshooting
Troubleshooting the FC/FCoE Driver
1086
Link Events (1300 - 1399)
elx_mes1300: Link Down Event in loop back mode
DESCRIPTION: Driver received a link down event while in loopback mode -
unexpected event.
DATA: None
ACTION: Software driver error. If this issue persists, report these errors to Emulex
technical support.
elx_mes1302: Invalid speed for this board: Reset link speed to auto:
<value>
DESCRIPTION: Driver detected an invalid link speed. Resetting Link to Auto mode.
DATA: (1) Invalid speed detected
ACTION: Software driver error. If this issue persists, report these errors to Emulex
technical support.
elx_mes1303: Link Up Event <eventTag> received Data: <value> <value>
<value> <value> <value> <value> <value>
DESCRIPTION: A link up event was received. It is also possible for multiple link events
to be received together.
DATA:(1) fc_eventTag, (2) granted_AL_PA, (3) UlnkSpeed, (4) alpa_map[0]
ACTION: If numerous link events are occurring, check the physical connections to the
Fibre Channel network.
elx_mes1305: Link Down Event <eventTag> received Data: <value>
<value> <value>
DESCRIPTION: A link down event was received.
DATA: (1) fc_eventTag, (2) hba_state, (3) fc_flag
ACTION: If numerous link events are occurring, check the physical connections to the
Fibre Channel network.
elx_mes1306: Link Up Event in loop back mode<eventTag> received Data:
<value> <value> <value> <value>
DESCRIPTION: Link up notification; configured for loopback.
DATA: (1) fc_eventTag, (2) granted_AL_PA, (3) UlnkSpeed, (4) alpa_map[0]
ACTION: None required.
elx_mes1308: Menlo Maint Mode Link up Event <value> rcvd Data: <value>
<value> <value>
DESCRIPTION: Link up notification in Menlo maintenance mode.
DATA: (1) fc_eventTag, (2) port_state, (3) VPort fc_flag