Dell Emulex Family of Adapters - Manual (Page 1472)

Boot for the Fibre Channel Protocol User Manual P010096-01A Rev. A
7. Configure EFIBoot via UEFI HII (Human Interface Infrastructure) in a UEFI 2.1 System
Start the Emulex Configuration Utility
1472
7. Configure EFIBoot via UEFI HII (Human
Interface Infrastructure) in a UEFI 2.1 System
EFIBoot is not supported on legacy converged network adapters (CNAs) such as the
LP21000 and LP21002.
If you have several adapters in your system, the UEFI system firmware or boot code
uses the highest version driver that is on one of your adapters. Adapters with older
versions of EFIBoot are managed by the more recent version, but only as long as the
adapter with the most recent version is in the system. The adapters must be updated
to actually update and not just use the most recent version available.
Start the Emulex Configuration Utility
Depending on the OEM UEFI configuration, the Emulex Configuration Utility may
appear under different setup menus in the OEM system firmware or BIOS. This
description applies to systems where the Emulex Utility is found under “System
Settings->Storage.”
To start the Emulex Configuration utility:
1. From the System Storage screen, select the Emulex HBA port and press <Enter>.
Figure 7-1 Storage Screen
Note: This screen is different for LPe16000 adapters, but the functionality is the same.