Dell Emulex Family of Adapters - Manual (Page 1378)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1378
Example:
elxvcpcmd v=12.345.678.901 u=username p=password h=12.345.678.123
setdcbpriority 10:00:00:00:c9:3c:f7:88 3 0,1,2,4,5,6,7 3 0 0 0 0 0 0
setdriverparam
Syntax
elxvcpcmd.exe v=<vcenter server> u=<vc_username> p=<vc_pwd> <h=ESXhostIP>
setdriverparam <WWPN | MAC> <Flag1> <Flag2> <Param> <Value>
Description
This command sets the driver parameter at the port or global level, either permanently
or temporarily for the specified port.
Parameters
setdriverparamdefaults
Syntax
elxvcpcmd.exe v=<vcenter server> u=<vc_username> p=<vc_pwd> <h=ESXhostIP>
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC or iSCSI port.
PFCPriorities
PFC priority that is a comma separated list of up to 7 values ranging
from 0-7.
Priorities of
PGID
Priority group membership that is a comma separated list of priorities
ranging in value for 0-7.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC port.
Flag1
L = Local (all adapters on this host)
G = Global (all adapters on this host)
Flag2
P = Permanent (persists across re-boot)
T = Temporary.
Param
The name of the driver parameter.
Value
The value of the driver parameter.