Dell Emulex Family of Adapters - Manual (Page 1597)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
8. Configuring iSCSI Boot Support with the iSCSISelect Utility
Setting Up a Basic iSCSI Boot Configuration
1597
3. Select Save and press <Enter> to save your initiator name.
Figure 8-1 iSCSI Initiator Configuration Menu
4. Select Controller Configuration and press <Enter>. If you are running a single
controller, the Controller Configuration menu is displayed (Figure 8-3). If you are
running multiple controllers, the Controller Selection menu is displayed
(Figure 8-2).
Figure 8-2 Controller Selection Menu
5. From the Controller Selection menu, select your controller and port then press
<Enter>. For more information, see “Selecting a Controller” on page 1600.
6. After you have selected your controller, the Controller Configuration menu
appears.
Figure 8-3 Controller Configuration Menu
7. From this menu, select Controller Properties and press <Enter>. The Controller
Properties screen appears. For more information on the Controller Properties
screen, see “Viewing the Controller Properties” on page 1601.
Figure 8-4 Controller Properties Screen
8. Ensure Boot Support is set to Enabled.
9. Select Save and press <Enter>.