Dell Emulex Family of Adapters - Manual (Page 143)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
FC/FCoE
143
5. Click Yes. The Change World Wide Name Configuration dialog box appears.
Figure 8-21 Change World Wide Name Configuration Dialog Box
6. Do one of the following:

Enter a new WWPN and/or WWNN.

Click Get Factory Default WWNs to load the settings that were assigned when
the adapter was manufactured to the New WWPN and WWNN settings. These
values can then be modified if desired and saved as Volatile or Non-Volatile
WWNs.

Click Get Non-Volatile WWNs to load the current Non-Volatile WWN settings
to the New WWPN and WWNN settings. These values can then be modified if
desired and saved to volatile or non-volatile memory. You can edit the data
returned from the button.
7. Check Write changes to volatile memory for temporary use to save the New
WWPN and New WWNN settings as Volatile WWNs. If unchecked, the New
WWPN and New WWNN settings are saved as Non-Volatile WWNs.
Note: If the adapter or firmware does not support Volatile WWNs, the “Write
changes to volatile memory for temporary use” checkbox is disabled.
8. Click OK. After checking for a duplicate WWPN, the new WWPN and new
WWNN values are saved for Volatile or Non-Volatile use. The new WWPN and
WWNN appear in the Pending Changes section in the WWN Management area of
the Maintenance tab until the system is rebooted.