Dell Emulex Family of Adapters - Manual (Page 1697)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
13. Configuring UEFI for FCoE
Configuring CEE FCF Parameters
1697
3. Select the CEE FCF record to modify and press <Enter>. The current record
information is displayed.
Figure 13-5 CEE FCF Record Information
4. Change the record information as needed.

Set Record State can be set to unused, active, or boot.

VLAN ID must be a three digit hexadecimal number.

Switch Name (Low). Enter the low bits of the FC switch’s WWN to which to
connect. This must be an 8-digit hexadecimal number.

Switch Name (Hi). Enter the high bits of the FC switch’s WWN to which to
connect. This must be an 8-digit hexadecimal number.

Fabric Name (Low). Enter the low bits of the FC fabric’s WWN to which to
connect. This must be an 8-digit hexadecimal number.

Fabric Name (Hi). Enter the high bits of the FC fabric’s WWN to which to
connect. This must be an 8-digit hexadecimal number.
5. Do one of the following:

To save your changes, select Commit Changes and press <Enter>. The changed
CEE FCF record information is displayed.

To discard all changes, select Discard Changes and press <Enter>. The CEE
record selection list is displayed (Figure 13-4).

To discard your changes and use the CEE parameters from the FCF table, select
Select From FCF Table and press <Enter>. The FCF table parameters are
displayed.
6. Press <Enter>. The Emulex Adapter Configuration Main Menu is displayed.