Dell Emulex Family of Adapters - Manual (Page 1710)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
13. Configuring UEFI for FCoE
Resetting Emulex Adapters to Default Values
1710
Note: The following example sets the default values for FC and FCoE adapters only.
To set other adapters to their default settings, you must use the utility for that
specific protocol.
To set Emulex adapters to their default settings:
1. From the Device Manager screen (Figure 13-2), select the adapter whose default
settings you want to change and press <Enter>.
2. From the Emulex Adapter Configuration Main Menu (Figure 13-3), select Set
Emulex Adapter to Default Settings and press <Enter>.
Figure 13-19 Set Adapter Defaults
Note: This will set the adapter to the FCoE driver default settings only.
3. Select Set Adapter Defaults and press <Enter> to set the adapter back to its default
values. The Emulex Adapter Configuration Main Menu is displayed.
4. From the Emulex Adapter Configuration Main Menu, select Back to Display
Adapters and RECONNECT DEVICES to complete configuration or select another
configuration option.
Bandwidth 0% Must have a total of 100% across all
ports.
LPVID 0 2–4094
Switch Option (IBM
Virtual Fabric-capable
configuration, if
available) IBM Virtual Fabric Mode IBM Virtual Fabric Mode
IBM Unified Fabric Protocol Mode
Switch Independent Mode
Table 13-1 Adapter Default Values (Continued)
Parameter Default Value Valid Values