Saving the configuration, Configuring multichannel for ibm adapters, Figure 11-18 – Dell Emulex Family of Adapters User Manual
Page 1649: Otocol mode, refer to “configuring
Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual
P010097-01B Rev. A
11. Configuring UEFI for Ethernet
Starting the Emulex NIC Configuration Utility
1649
4. When you are finished configuring LPVIDs, press <Esc> to return to the Controller
Configuration screen.
Saving the Configuration
To save the configuration changes, on the Controller Configuration screen, select Save
Configuration and press <Enter>.
Configuring Multichannel for IBM Adapters
Note: This section only pertains to certain Emulex OneConnect adapters that support
IBM Virtual Fabric multichannel or Unified Fabric Protocol.
Multichannel provides the ability to configure multiple PCI functions or I/O channels
for each adapter port.
Note: Setting up IBM Virtual Fabric or UFP multichannel depends on cooperation
with adjacent switches.
To enable multichannel support:
1. On the Emulex NIC Selection screen, select Multichannel Mode and press <Enter>.
The Multichannel Mode pop-up menu appears.
Figure 11-18 Multichannel Mode Dialog Box
2. Select one of the following settings and press <Enter>:
Switch Independent Mode
IBM Virtual Fabric Mode
IBM Unified Fabric Protocol Mode