Dell Emulex Family of Adapters - Manual (Page 308)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
2. Installing and Uninstalling the CLI
Windows
308

excl – This optional switch allows the non-management-host user to select
whether the OneCommand Manager application will process requests
exclusively from the Management Host specified by the MHost switch. This
option is only accepted if accompanied by a valid MHost value; otherwise
an error message appears. If this switch is not specified, the default value of
0 will be used. If the switch is specified, the valid values are:
0 – Remotely managed by other hosts.
1 – Remotely managed by Management Host ONLY.

Mtcp – This optional switch allows you to enable or disable remote
management and to specify the TCP/IP port number over which
management will occur. If this switch is not specified, the default TCP/IP
port number 23333 will be used.
If the management host option is selected, you must either select the default
port number or enter a valid TCP/IP port number on the command line. A
value of 0 will not be accepted.
If one of the non-management host options is selected, you can enter the
TCP/IP port number on the command line.
Uninstalling in Windows
There are two ways to uninstall the OneCommand Manager CLI in Windows:

Through the control panel

Through the command line
Uninstalling through the Control Panel
To uninstall the OneCommand Manager CLI in Windows through the control panel:
1. In Windows 2008 and Windows 2008 R2, select Start > Control Panel > Programs >
Uninstall a Program.
2. If present, select Emulex Common SAN Management [version], and click Remove
or Uninstall. Click Yes.
The Emulex Common SAN Management components are removed from the
system.
3. Select Emulex OCManager CLI [version] and click Remove or Uninstall.
Uninstalling through the Command Line
To uninstall the OneCommand Manager CLI in Windows through the command line:
1. Change to the appropriate uninstall directory:
cd <Install Location>\Emulex\Util\Uninstall
2. Type
uninstall_OCManager_Core.bat