Figure 11-10 – Dell Emulex Family of Adapters User Manual
Page 1640
Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual
P010097-01B Rev. A
11. Configuring UEFI for Ethernet
Starting the Emulex NIC Configuration Utility
1640
Configuring the Controller When Multichannel is Disabled or
Not Supported
Note: If your adapter has Multichannel Mode enabled, refer to “Configuring
Universal Multichannel” on page 1644. If you are using an IBM adapter, refer to
“Configuring Multichannel for IBM Adapters” on page 1649.
When Multichannel Mode is disabled, or it is not supported, the following Controller
Configuration screen appears when you select Controller Configuration on the
Emulex NIC Selection Screen.
Figure 11-10 Controller Configuration Screen
The Controller Configuration screen enables you to perform the following tasks:
View the current configuration
Configure SR-IOV
Configure NIC Mode
Note: This setting is only available when SR-IOV is enabled, the Personality
Selection is set to “NIC”, and a two-port OCe14000-series adapter is in
use.
Save the current configuration