Dell Emulex Family of Adapters - Manual (Page 1694)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
13. Configuring UEFI for FCoE
Starting the Emulex FCoE Configuration Utility
1694

Select Back to Display Adapters and RECONNECT DEVICES from the
Emulex Adapter Configuration Main Menu when you are finished to ensure the
changes are made active; otherwise, a system restart is required to make your
changes active.You are then returned to the adapter list.
Starting the Emulex FCoE Configuration Utility
Depending on the OEM UEFI configuration, the Emulex FCoE configuration utility
may appear under different setup menus in the OEM system firmware or BIOS (such as
System Settings > Storage). This description applies to systems where the Emulex
utility is found in the Device Manager.
To start the Emulex FCoE configuration utility using HII:
1. Exit the EFI shell.
Figure 13-1 Exiting the EFI Shell
2. A front page is displayed. Launch the Device Manager.
3. On the Device Manager screen, a list of all the adapters in the system is displayed.
Your list may vary depending on the installed adapters. Locate the adapter you
want to configure. Use the up/down arrows on your keyboard to select it, and
press <Enter>.
Figure 13-2 Device Manager Screen