Dell Emulex Family of Adapters - Manual (Page 66)

OneCommand™ Manager Application P010066-01A Rev. A
2. Installing and Uninstalling OneCommand Manager Application Components
Installing the OneCommand Manager Application
66
9. When prompted, enter the type of management you want to use:
Enter the type of management you want to use:
1 Local Mode : HBA's on this Platform can be managed by
OneCommand clients on this Platform Only.
2 Managed Mode: HBA's on this Platform can be managed by local or
remote OneCommand clients.
3 Remote Mode : Same as '2' plus OneCommand clients on this
Platform can manage local and remote HBA's.
4 Management Host : Same as '1' plus OneCommand clients on this
Platform can manage remote HBA's.
Note: If you enabled Secure Management in step 8, you cannot configure
management mode.
If you select option 2, you are asked if you want to enable TCP/IP management
from remote hosts.
If you select option 3, you are asked if you want to enable TCP/IP management of
remote hosts, and enable TCP/IP management from remote hosts. You are
prompted to enter the TCP/IP port number to use. (Leaving the field blank defaults
to 23333.)
If you select options 2 or 3, you are prompted for the management host address.
(Leaving the field blanks means none.)
You can enter an IP address or host name. If you enter a management host address,
you are prompted to exclude management of this host from any other host.
If you select option 4, management of remote hosts is automatically selected and
you are prompted to enter the TCP/IP port number to use. (Leaving the field blank
defaults to 23333.)
Note: Management hosts cannot be managed by remote hosts.
10. If you answered 2, 3, or 4 in step 9, you must decide whether you want the
OneCommand Manager application to operate in read-only mode. Read-only mode
prevents users from performing certain operations such as resetting adapters,
updating an adapter's firmware and changing adapter driver properties and
bindings. It only affects the local OneCommand Manager application interface.
These operations can still be performed using remote management. Enter <y> for
yes to allow users to perform these operations, enter <n> for no if read-only mode is
desired.
11. You are prompted about allowing users to change the management mode after
installation. Enter <y> for yes, or <n> for no.
Unattended Installation in Linux
For unattended installation of the OneCommand Manager application for Linux,
installation settings are defined using the install script command line.
Note: Prior to installation, OneCommand groups must be configured on the LDAP
network or the local host machine for Secure Management operation. See