Dell Emulex Family of Adapters - Manual (Page 117)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
FC/FCoE
117

Port Speed – The current port speed of the selected adapter port.
Loop Map Table Definitions

The loop map shows the different ports present in the loop, and is present only
if the port (adapter) is operating in loop mode. The simplest example would be
to connect a JBOD directly to an adapter. When this is done, the port type is a
private loop, and the loop map has an entry for the adapter, and one entry for
each of the disks in the JBOD. (Not supported on VMware ESXi servers being
managed through the CIM interface. Not supported for COMSTAR ports.
COMSTAR ports are supported on OpenSolaris only.)
Port Information Buttons

Enable\Disable Port – Click to enable or disable the selected FC port. See
“Configuring iSCSI Port Initiator Login Options” on page 178 for more
information.
Note: Enable/Disable Port is not supported via the CIM interface.
Viewing FCoE Port Information
When you select an FCoE port from the discovery-tree, the Port Information tab
contains general attributes associated with the selected FCoE port.
To view FCoE Port information:
1. Select Host or Fabric view.
2. Select an FCoE port in the discovery-tree.