Dell Emulex Family of Adapters - Manual (Page 201)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
OneConnect Adapters
201
Viewing the Channel Management Tab for UFP (IBM only)
For IBM adapters that support UFP, the UFP properties are displayed in the Channel
Management tab (when UFP is enabled). The Port Channel Management Tab for UFP is
read-only.
Note: UFP is supported only on IBM virtual fabric adapters. For specific information
as to whether it is supported on a specific adapter, see the release notes that are
available on the IBM adapter pages on the Emulex website.
Figure 8-58 Channel Management Tab for UFP (IBM only)
To view UFP channel management:
1. From the discovery-tree, select the UFP adapter port whose channel information
you want to view.
2. Select the Channel Management tab.
Channel Management Field Definitions for UFP (IBM only)

Channel Management Type (Read-only) – The type of channel management
type in use.

Func. Num. (Read-only) – The function number assigned by the system to the
channel.

Type (Read-only) – The protocol type in use by the channel.

MAC address (Read-only) – The MAC address assigned to the channel.

Name – The name assigned to the vNIC by an administrator during switch
configuration.

Outer VLAN ID – The VLAN identifier used between the NIC port and the
switch. The switch maps this value into the VLAN ID used on the network.