Dell Emulex Family of Adapters - Manual (Page 1556)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
3. Configuring PXE Boot for NIC on OCe14000-series Adapters
PXE Boot Parameters Default Values
1556
PXE Boot Parameters Default Values
The default settings for the PXE Boot parameters are listed in the following table.
Table 3-1 PXE Boot Parameter Default Values
Parameter Default Value Valid Values
Multichannel The default for this parameter varies
depending on the vendor
configuration. For Emulex adapters:
• Enabled
• Disabled
For IBM adapters:
• IBM Virtual Fabric Mode
• IBM Unified Fabric Protocol Mode
• Switch Independent Mode
• Disabled
Personality The default for this parameter varies
depending on the vendor
configuration. When multichannel is enabled:
• NIC
• iSCSI
• FCoE
• Custom
When multichannel and SR-IOV are
disabled:
• NIC
• iSCSI
• FCoE
• NIC+RoCE
Note: RoCE is supported on Windows
only.
When multichannel is disabled and
SR-IOV is enabled:
• NIC
• iSCSI
• FCoE
SR-IOV Disabled Enabled
Disabled
RoCE Profile
Note: This setting is
only available
when the
NIC+RoCE
personality is
selected.
RoCE-1 RoCE-1
RoCE-2
Minimum Bandwidth 0% Must have a total of 100% across all
ports.
Maximum Bandwidth 0% From the minimum bandwidth value up
to 100% (inclusive).
LPVID 0 2–4094