Dell Emulex Family of Adapters - Manual (Page 586)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
3. Configuration
FC/FCoE Driver Configuration
586
ScanDown=n If set to 0 = lowest AL_PA = lowest physical disk
(ascending AL_PA order).
If set to 1 = highest AL_PA = lowest physical disk
(ascending SEL_ID order).
Value: 0–1
Default = 1
Note: This option applies to private loop only in
DID mode. Reboot FC Only
SLIMode=n If set to 0 = autoselect firmware, use the latest
firmware installed.
If set to 2 = implies running the adapter firmware
in SLI-2 mode.
If set to 3 = implies running the adapter firmware
in SLI-3 mode.
Value: 0, 2, and 3
Default = 0 Reboot LightPulse Only
SrbTimeout SrbTimeout limits the SRB timeout value to 60
seconds when set to 1 or enabled. This is a
non-displayed parameter where it has to be set
manually into the registry. This option alters the
I/O timeout behavior where an I/O will be
returned in a max timeout of 60 seconds on some
long I/O timeout.
If set to 1 = enabled
If set to 0 = disabled
Values: 0, 1
Default = 0
Topology=n Topology values can be 0 to 3.
If set to 0 (0x0) = FC-AL.
If set to 1 (0x1) = PT-PT fabric.
If set to 2 (0x2) = *FC-AL first, then attempt
PT-PT.
If set to 3 (0x3) = *PT-PT fabric first, then
attempt FC-AL.
* Topology fail-over requires v3.20 firmware or
higher. If firmware does not support topology
fail-over, options 0,2 and 1,3 are analogous.
Value: 0–3
Default = 2 (0x2) Reset FC Only
Table 3-1 Storport Miniport Driver Parameters (Continued)
Parameter Definitions
Activation
Requirement
Adapter/Protocol