Dell Emulex Family of Adapters - Manual (Page 394)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
LUN Masking Commands
394
UpdateiSNSServer
This command updates a configured iSNS server and accepts IPv4 or IPv6 iSNS server
addresses. This command requires the server IP <Server_IP> and port number <Port>
of the iSNS server to be available to respond to the iSNS requests. If a single iSNS server
is configured, this command replaces the single iSNS server IP address with a new IP
address. If no iSNS server is configured, this command adds a new iSNS server.
Note: If two or more iSNS servers are already configured, any attempt to use this
command results in an error.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
UpdateiSNSServer <MAC_Address> <Server_IP> <Port>
Parameters
LUN Masking Commands
Notes

Supported for FC/FCoE ports only.

Linux does not support the GetLunUnMaskByHBA, GetLunUnMaskByTarget,
and SetLunMask commands.

Solaris and VMware ESXi do not support the GetLunUnMaskbyHBA,
GetLunUnMaskbyTarget, RescanLuns, and SetLunMask commands.
GetLunList
This command queries for the presence of any masked LUNs.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
GetLunList <HBA WWPN> <Target WWPN> <Option>
MAC_Address
The MAC address of an iSCSI port.
Server_IP
IP address of the iSNS server to configure. You can specify an IPv4 or
IPv6 server IP address.
Port
Port number of the iSNS server to configure (value: 1024–65535).