Dell Emulex Family of Adapters - Manual (Page 362)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Driver Parameter Commands
362
Example
hbacmd TDRTest <MAC>
The example output:
Pair A: OK. Cable Length Estimation: 50m.
Pair B: OK. Cable Length Estimation: invalid.
Pair C: Open. Distance to Fault: 38m.
Pair D: Shorted. Distance to Fault: 36m.
Wakeup
Note: Not supported for OneConnect and LPe16200-series adapters.
This command shows the firmware's wakeup parameters for the adapter.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
Wakeup <WWPN>
Parameters
Driver Parameter Commands
Notes

Supported for FC and FCoE ports only.

Driver parameters that are set to temporary or global values (using the “T” and
“G” flags, respectively) must be read using the GetDriverParams command to
view the current value of the parameter. The GetDriverParamsGlobal command
returns only permanently set driver parameter values.
Additionally, if temporary and global values have been set for one or more
driver parameters, the “SaveConfig” command must be run with the “N” flag
(using the “N” flag is analogous to the GetDriverParams command) to force the
driver parameter values for the specified adapter to be saved. Inaccurate values
may be saved if the “G” flag is used for this command.

The DriverConfig and SetDriverParamDefaults commands are not supported
for Solaris.

The list of available driver parameters that can be configured are different
depending upon the operating system and protocol (FC or FCoE).
WWPN
The WWPN of an FC port.