Dell Emulex Family of Adapters - Manual (Page 387)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
iSCSI Commands
387
Notes

VLAN_ID and Priority are required only if VLAN_ENABLED is enabled;
otherwise, these values should be omitted.

IPv4_Address and Subnet are required only if DHCP is disabled; otherwise
these values should be omitted.

At a minimum, the DHCP or AA parameter must be specified and, if required,
their associated parameters as well. If either the DHCP or AA parameter is not
specified an error results.
SetTargetLoginProperties
This command sets the login and authentication properties associated with a specific
target. This command requires that you specify a valid iSCSI target name
<iscsi_target_name>. If you do not specify some of the remaining properties, these
options are set to their default values. However, if no properties are changed, an error
is generated. You must change at least one property for this command to return
successfully.
When you set the authentication method <Auth> to a value other than 0, you must set
additional parameters. Each string should be enclosed in quotations to avoid
mishandling by the Windows, Linux, Solaris, or VMware shell’s parser.

If you set the authentication method to “One-Way CHAP” (<Auth>=1), you
must also specify the “Target CHAP Name” and “Target Secret.” For example:
hbacmd SetTargetLoginProperties 00-11-22-33-44-55 iscsitarget
Auth=1 "TgtCHAPName" "TargetSecret1"

If you set the authentication method to “Mutual CHAP” (<Auth>=2), you must
specify all four values. For example:
hbacmd SetTargetLoginProperties 00-11-22-33-44-55 iscsitarget
Auth=2 "TgtChapName" "TargetSecret1" "InitCHAPName"
"InitialSecret1"
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetTargetLoginProperties <MAC_Address> <iscsi_target_name>
[ImmediateData=<0|1>] [HeaderDigest=<0|1>] [DataDigest=<0|1>]
[Auth=<0|1|2> "TgtCHAPName" "TgtSecret" "InitCHAPName" "InitSecret"]
Parameters
MAC_Address
The MAC address of an iSCSI port.
iscsi_target_name
Target’s iSCSI name enclosed in quotes (string length: 11–255).
ImmediateData
0 = No
1 = Yes (default)
HeaderDigest
0 = None (default)
1 = CRC32C