Dell Emulex Family of Adapters - Manual (Page 1365)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1365
Parameters
Example:
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password>
h=<esx_host> loopbacktest 00-00-c9-93-2f-9f 4 120 0
pcidata
Syntax
elxvcpcmd.exe v=<vcenter server> u=<vc_username> p=<vc_pwd> <h=ESXhostIP>
pcidata <WWPN | MAC>
Description
This command shows the PCI attributes for the port specified on the adapter.
Parameters
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
MAC
The MAC address of the NIC or iSCSI port.
Type
Type of loopback test to run:
0 = PCI LoopBack Test
1 = Internal LoopBack Test
2 = External LoopBack Test (requires loopback plug)
3 = DMA Loopback Test
4 = PHY Loopback Test
5 = MAC Loopback Test
Note: Loopback tests 0 and 1 are not supported for UCNAs.
Loopback tests 3, 4 and 5 are only supported for UCNAs.
Count
The number of times to run the test (0 = run test infinitely, Range =
1...99,999)
StopOnError
Checks if the test must be halted on error.
0 = No halt
1 = Halt
Pattern
(optional)
1 to 8 hexadecimal bytes to use for loopback data (for example:
1a2b3c4d)
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.