Dell Emulex Family of Adapters - Manual (Page 1104)

Emulex Drivers Version 10.2 for VMware ESXi User Manual P010087-01A Rev. A
4. Troubleshooting
Troubleshooting the FC/FCoE Driver
1104
elx_mes2514: POST_RPI_HDR mailbox failed with status <shdr_status>
add_status <shdr_add_status>, mbx status <rc>
DESCRIPTION: The mailbox command sent to post the RPUI header pages to the
firmware has failed.
DATA: None
ACTION: None required.
elx_mes2515: ADD_FCF_RECORD mailbox failed with status <rc>
DESCRIPTION: The mailbox command to add the FCF record has failed.
DATA: None
ACTION: None required.
elx_mes2521: READ_FCF_RECORD mailbox failed with status <shdr_status>
add_status <shdr_add_status>, mbx
DESCRIPTION: The READ_FCF_RECORD mailbox command has failed.
DATA: None
ACTION: None required.
elx_mes2522: Synchronous READ_FCF_RECORD mailbox failed with status
<value> add_status <value>
DESCRIPTION: Driver failed to read the active FCF Record on an FCoE link - FCF may
not be available.
DATA: None
ACTION: Software driver error. If this issue persists, report these errors to Emulex
technical support.
elx_mes2523: Allocated DMA memory size (<alloc_len>) is less than the
requested DMA memory size (<req_len>)
DESCRIPTION: The ADD_FCF_RECORD mailbox command failed to retrieve the
length required from the firmware.
DATA: None
ACTION: None required.
elx_mes2524: Failed to get the non-embedded SGE virtual address
DESCRIPTION: The READ_FCF_RECORD mailbox command could not retrieve the
Scatter Gather Entry (SGE) that was requested.
DATA: None
ACTION: None required.