Dell Emulex Family of Adapters - Manual (Page 1672)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
12. Configuring UEFI for iSCSI
Configuring the Network
1672
Manually Assigning an IP Address
To manually assign an IP address:
1. On the Configure IPV4 Address screen (Figure 12-8), ensure that the Initiator IP via
DHCP is set to <Disable>. If you change this setting from <Enable> to <Disable>,
select Save DHCP Settings and press <Enter>.
2. Select Configure Static IP Address and press <Enter>. The Configure Static IP
Address screen appears.
Figure 12-9 Configure Static IP Address Screen
3. Enter the IP address, subnet mask, and default gateway in the corresponding fields.
4. Select Save Changes and press <Enter>.
Pinging the iSCSI Initiator
To ping the iSCSI initiator, on the Configure IPV4 Address screen (Figure 12-8), select
Ping and press <Enter>.

If the ping is successful, a reply message is displayed with the iSCSI initiator IP
address.

If the ping is not successful, a failure message is displayed.