Dell Emulex Family of Adapters - Manual (Page 398)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Miscellaneous Commands
398
Parameters
Example
>hbacmd h=10.192.87.198 SetExpressLaneLUNState 10:00:00:00:00:87:01:98
20:22:d4:ae:52:6e:6f:08 2 1 2
Miscellaneous Commands
AddHost
This command adds a host to the hosts file for TCP/IP management in the
OneCommand Manager GUI. The adapters for these hosts are also presented by the
ListHBAs command.
Supported By
Linux, Solaris, and Windows
Syntax
To add non-VMware ESXi hosts:
hbacmd AddHost <host_address>
Note: The “h=” option (for specifying an optional IP address or host name) after
“hbacmd” is not available for the AddHost command.
To add VMware ESXi hosts to Windows OCM:
hbacmd m=cim [u=<username>] [p=<password>] [n=<namespace>] AddHost
<IP_Address>
If the username, password, and namespace are not specified, see “Default CIM
Credentials” on page 316.
WWPN
The WWPN of the FC/FCoE function connected to the target or
physical WWPN if virtual ports are selected.
vPORT WWPN
The WWPN of an optional vPort allowing you to set the state of a
vPort LUN.
Target WWPN
The WWPN of the target LUNs.
LUN
The LUN number on which to set the ExpressLane status.
Note: Obtain the LUN number from the output of the GetExpressLaneLunList
command under the “OS LUN” column.
State
0=Disable ExpressLane, 1=Enable ExpressLane
Option
0=Set ExpressLane LUN state in driver temporary - until reboot
1=Set ExpressLane LUN state in the configuration to persist across
reboots
2=Set ExpressLane LUN state in both driver and in the configuration
to persist across reboots