Dell Emulex Family of Adapters - Manual (Page 582)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
3. Configuration
FC/FCoE Driver Configuration
582
DriverTraceMask The DriverTraceMask parameter is only available
on operating systems that support extended
system event logging.
If set to 0 = the parameter is disabled.
If set to 1 = error events logging is enabled.
If set to 4 = warning events logging is enabled.
If set to 8 = informational events logging is
enabled.
The values can be masked to generate
multi-levels of events logging.
Values: 0, 1, 4, and 8.
Default = 0. Dynamic
EnableAck0=n Set to 1 to force sequence rather than frame level
acknowledgement for class 2 traffic over an
exchange. This applies to FCP data exchanges on
IREAD and IWRITE commands.
Value: 0–1 (decimal)
Default = 1 Reset FC only
EnableAUTH EnableAUTH enables fabric authentication. This
parameter requires the authentication to be
supported by the fabric. Authentication is
enabled when this value is set to 1.
Value: 0–1
Default = 0 Reboot FC only (up to and
including 8 Gb)
EnableFDMI=n If set to 1, enables management server login on
fabric discovery. This allows FDMI to operate on
switches that have FDMI-capable firmware.
If set to 2, FDMI operates and uses the host name
feature of FDMI.
Value: 0–2 (decimal)
Default = 0 Reset
EnableNPIV=n If set to 1, enables NPIV. Requires NPIV supported
firmware for the adapter.
Value: 0–1
Default = 0 (disabled)
Notes:
• To run the driver using NPIV or SLI-3
optimization, the firmware must be version
2.72a0 or later. If an earlier version is used,
the driver runs in SLI-2 mode and does not
support NPIV.
• NPIV is not available on 1 Gb/s and 2 Gb/s
adapters.
Reboot
Table 3-1 Storport Miniport Driver Parameters (Continued)
Parameter Definitions
Activation
Requirement
Adapter/Protocol