Dell Emulex Family of Adapters - Manual (Page 1113)

Emulex Drivers Version 10.2 for VMware ESXi User Manual P010087-01A Rev. A
4. Troubleshooting
Troubleshooting the FC/FCoE Driver
1113
elx_mes2719: Invalid response length: tgt <TGT_ID> lun <LUN> cmnd
<CMD> rsplen <RSPLEN>
DESCRIPTION: The response length for this FCP command is not supported.
DATA: None
ACTION: None required.
elx_mes2723 PCI channel I/O abort preparing for recovery
DESCRIPTION: Driver is preparing port PCI channel for reset/recovery after I/O
error.
DATA: None
ACTION: Software driver error. If this issue persists, report these errors to Emulex
technical support.
elx_mes2726: READ_FCF_RECORD Indicates empty FCF table
DESCRIPTION: The driver requested the firmware provide a list of FCF entries to
connect to and the firmware responded that the FCF table is empty.
DATA: None
ACTION: None required.
elx_mes2729: Unable to dma_map_single request_buffer: <value>
DESCRIPTION: Driver unable to map SCSI command scatter-gather buffer.
DATA: (1) dma mapping error.
ACTION: Software driver error. If this issue persists, report these errors to Emulex
technical support.
elx_mes2731: Cannot find fabric controller node.
DESCRIPTION: Driver not able to find Fabric controller node in its data base.
DATA: None
ACTION: None required.
elx_mes2732: Failed to issue INIT_VPI mailbox command.
DESCRIPTION: The driver wanted to send a INIT_VPI mailbox command to initialize a
VPort, but failed to send the mailbox command due to state of the adapter.
DATA: None
ACTION: None required.
elx_mes2745: Failed to allocate mbox for requesting FCF rediscover
DESCRIPTION: Driver is trying to rediscover FCF table, but failed to allocate memory
needed.
DATA: None